Het Drabus® Combidrill is a two-in-one tool that makes it possible to make a friction drilled bush with a thread iin it all at once. So, instead of making a friction drilled hole and afterwards using a form trap, now you can do it with one tool: the Drabus® Combidrill!
With this new technology there are 2 remarks. First, the Combidrill has to leave the formed hole with teh same step and reversed anti-clockwise speed, otherwise it will deform the threaded hole.
Second, until now Drabus® Combidrills are only available for the dimensions M6, M8 and M10.
See the table below for the articlenumbers.
For more information about this new technology, do not hesitate to contact us.

The Drabus® Alu-Frictiondrill is an new developed frictiondrill with a special geometry to make holes in thin Alu-material (plates, profiles, tubes, etc.) These Drabus® Alu-Frictiondrills have a special coated surface and go perfectly with Drabus® Alu-paste. They are available now for the dimensions M4, M5, M6 and M8. See the table below for the articlenumbers. For more information about this new technology, do not hesitate to contact us.